Säljes 19 mar Malmö

Alexander Pedals Space Force

Denna passade inte riktigt in i min pedal setup så får gå igen. Sprillans nytt, har bara testat det. Inköpt den 5:e mars.

Nypris hos tysken: 3 333 kr
Köp nu 2500 kr

REVERB ENGINES:
PLATE: Based on a vintage studio reverb, this simulates the reflective properties of a giant metal plate. We’ve also included a virtual tape pre-delay and adjustable tape flanging modulation.

MOD HALL: Classic 1980s electronic hall reverb with adjustable pitch modulation. We’ve added high and low EQ controls to allow for fine-tuning the reverb tone.

PITCH: Chamber reverb effect with twin adjustable pitch shifters. Each shifter has selectable intervals ranging from a detune effect to an octave. Try with detune or down an octave for a cool textural wash.

SPRING: Surf’s up! Spring reverb effect with multi-wave tube bias type tremolo. We’ve placed the tremolo after the reverb to ensure that it stays juicy no matter how wet you run the springs.

LO-FI: 1990s style electronic reverb with distortion on the reverb trails. Classic “shoegaze” effect, try this with the SAW modulation to simulate whammy bar guitar.

ANALOG: “Electronic” reverb based on an obsolete analog delay chip, these units were often used in karaoke machines and have a distinctive tone. Keep the time knob low for reverb or increase for cascading delay effects.

DYNAMIC: Large cathedral-style reverb with a volume-sensing fade effect. GATE mode will cut off the reverb like ‘80s drums, BLOOM will fade in just the reverb signal, and SWELL fades in both wet and dry for a more intense effect.

ECHOVERB: Room reverb and delay in parallel. Each effect has its own set of controls and is independent. The delay effect works even when the reverb effect is in the HOLD / FREEZE state.

PRESETS
THIRTY-TWO built-in presets (four banks of 8) allow you to colour with all the crayons in the box. Hold the Bypass / Preset footswitch to select the next preset, or hold both footswitches for the previous.

BYPASS TRAILS
The reverb + delay trails are configurable for hard bypass, full trails, or auto trails. In auto trails mode, the reverb will decay normally and then seamlessly ramp to zero volume for the lowest possible operating noise.

EXPRESSION AND RAMPING
Seamlessly morph between different knob settings on the fly using the built-in ramp footswitch, expression pedal, footswitch, or MIDI controller.

STEREO INS AND OUTS
The input jack is selectable for standard mono or TRS stereo signal input without opening the pedal. The output jacks are usable as either mono, two-cable stereo, or TRS stereo. Connect all your Venture and Leap Series pedals in stereo with TRS cables for a neat and tidy pedalboard!

MULTIJACK
Connect an expression pedal, footswitch, or MIDI controller to this jack to add performance control to your pedal.

USB PORT
Every Leap Series pedal features a USB port for MIDI control and firmware updates.

Mono or stereo input (TRS)
Mono or stereo output (TRS or dual outputs)
Input Impedance: 1M ohms
Output Impedance: 560 ohms
DC 9V only, 250mA or greater
Requires isolated DC power supply
4.7” x 2.6” x 1.5” H x W x D not including knobs
Eight reverb engines
32 user presets, arranged in 4 banks of 8
MultiJack enables expression pedal, foot switch, or MIDI input
EXP Morph allows controlling all knobs from expression pedal, ramp footswitch, or MIDI
Automatic ramping function for expression control without external pedal
CTL footswitch for tap tempo and ramp trigger
USB port for firmware updates and USB MIDI
Buffered bypass